i have huskvarna chain saw that bogs down when I give it gas. I have rebuilt carburator, taken off air filter and spark arrestor?

Answer 1

You should be asking in the Maintenance & Repair forum in the HOME & GARDEN category. This is Cars & Transportation and you can't ride a chainsaw. Duhhh.

Answer 2

Bogging down usually means you are to lean in the carb settings, start with 1-1/2 turn out on both highspeed and low speed screws, low speed is the one closest to engine (idle mix). Other cause is broken/cracked/bent reed though not all engines use them. But I doubt it if engine idles.  Other cause is improper setting of fuel inlet needle did you put gasket on correct side of diaphragm? muffler Plugged up with carbon.

Answer 3

Put the air filter and spark arrestor back on and try again.

Answer 4

Make sure the gas is fresh. You probably still have a plugged passage in the carb.