In a bathroom sink drain, is the dissimilar metals joint I see there a soldered joint, done with a torch?
There is a copper pipe coming out of the wall, connected to a chrome piece. That is the joint I mean.
In other words, how was the copper pipe which comes out of the wall joined to the chrome piece that connects to the p-trap? Is it a soldered joint, done with a torch? I remember when YA permitted photos to be used here.
- GediaLv 42 weeks ago
If you google plumbing fitting joints you will find many are crimps ( sneezed tight joints, with special tool, pliers , no need to solder many joints now ! Quick and cheaper to do the job, but still good, if done correctly.
- EarleenLv 54 weeks ago
Modern plumbing uses simple compression gaskets. Generally the sewer pipe is PVC plastic and not copper. One of the drain fittings is sized so that the PVC/copper pipe will insert into it. That fitting has threads and there is a nut that is made up on the threads. Inside the nut is a wedge shaped gasket. So, you put the pipe inside the fitting and tighten the nut, the gasket wedges against the pipe and forms a seal. It works for low pressure gravity drains/static water. It is not much and simpler that you would expect. Thanks to plastic being the perfect material for sewers. Go to the hardware store and look at the drain plumbing. You will see how it fits together. The more expensive way is metal and it is not as good. It will eventually corrode out after 25 years + or -.
- yLv 74 weeks ago
Many of those chrome/nickle looking fittings have a copper lining to them. That enables them to be soldered. I do not know if that is what you are looking at or not. There are some designed to look like they are all one piece or soldered but are actually threaded inside.
- STEVEN FLv 74 weeks ago
You didn't include a photo, so we can't tell what kind of joint is used.
YA STILL allows photos.
- How do you think about the answers? You can sign in to vote the answer.
- 4 weeks ago
- NancyLv 64 weeks ago
That isn't a problem. You just have to make sure both metals are clean, usually sanding or steel-wooling it and then heating it up with flux, and then, when soldering, making sure both metals get hot enough under the blowtorch that the solder fully adheres to both metals.
- pucman1961Lv 74 weeks ago
Your question still not understood.. Your making statements