Is it okay to use two power extension cords connected to each other?
- John PLv 71 year ago
In general, yes, but you need to think about a couple of things.
Voltage drop over a long total cable length - no worries for a computer or TV, but important for kettles and heaters.
The danger of connecting too many devices if each cable has multiple outlets.
Also the danger of water and electricity coming into contact if you are using the extensions outdoors. Wrap the junctions in plastic bags etc.
All in all, maybe get local advice from somebody who really knows about electricity concerning the particular set-up which you want to use.
- Jeffrey KLv 61 year ago
Sure it is.
- Andrew SmithLv 71 year ago
It is "sort of" OK.
Consider two 3 m cords in series. 6m long. Now there is some resistance in the plug but it still has less resistance than a single 10m cord.
The limit to the length is to do with the power drop.
I live on a farm and the wires leading to me drop 10 V for every kw I consume.
so if I use a welder the volts drop from 245 down to 215 approximately.
If I use a 20 m cord I lose another 15 volts. Now I am only getting 200 v
Now the amount of loss depends on the amount of current being used.
So if you have a low drain thing like a light bulb you could have 200 m or more of power cord with minimal loss.
As you increase the power required the losses mount quickly.
The formula is P = i^2 R
or for the volts lost V = iR
Which means that if you have a cord that is working fine on a 2kw device then you could use 2 of these in series on a 1kw device for the same loss of power.
It is quite safe IF you make sure that you only use it for lower current/load.
If you really need higher current and load over a longer distance then you need to purchase a much higher rated cord which has more copper in it and is very expensive.
- goringLv 61 year ago
Electric cords are rated by the amount of power they can carry with a minimal voltage drop at a particular length
if the length is exceeded an over voltage drop can occur and the motor at the other end wont be able to start..
- How do you think about the answers? You can sign in to vote the answer.
- VamanLv 71 year ago
No problem. Do not connect them in series. The voltage will be doubled and your equipment will get burnt. You can connect them in parallel.
- busterwasmycatLv 71 year ago
It can be. It is always better to use one that is designed to go the distance than to chain two. It should not be a problem, but any link is a weaker point that a direct wire. a potential point of exposure to a short or something.
As long as you do not exceed the capacity for power of the weakest cord, you should be all right.
- R KLv 71 year ago
- StacieLv 41 year ago
Yes, completely okay.
- billrussell42Lv 71 year ago
yes, within limits. I wouldn't run full capacity loads (for example, 10 amp load with cords rated at 10 amps) on two 100 ft cords.
For example, I have an AC where I have to run about 25 ft of extension cable, and I used a 20 foot and a 6 foot one, no problem. The AC is 10 amps and I was careful to use 10 amp or higher cables.
- 1 year ago
No you could cause all the electricity to be used up and there will be national blackouts, you may even blow a fuse