approach a million: confirm your clicking approach confirm which you're appearing a real single actual click. A single-click happens once you press and launch a mouse button one time. approach 2: attempt the mouse in distinctive courses close all courses and attempt for the undertaking on the computing device and in different aspects of Microsoft homestead windows, mutually with administration Panel or Microsoft homestead windows Explorer. If the undertaking basically happens in a undeniable software, troubleshoot that software. this equipment is maximum probable customizing the mouse instructions. approach 3: attempt the mouse in risk-free mode to start homestead windows XP in risk-free mode, stick to those steps: a million. click initiate, click close Down, and then click close Down in the drop-down record. 2. in the close Down homestead windows communique field, click Restart, and then click ok. 3. once you acquire here message, press the F8 key: Please go with the working equipment to start 4. Use the arrow keys to go with the applicable risk-free mode determination, and then press enter. 5. in case you have a twin-boot or distinctive-boot equipment, go with the setting up for you to get right of entry to by using employing the arrow keys, and then press enter. 6. attempt the mouse. 7. to bypass away risk-free mode, restart the computing gadget and permit it initiate in customary mode. If the undertaking does no longer take place in risk-free mode, there's a utility anomaly; bypass to approach 4. approach 4: Troubleshoot your utility verify your mouse properties settings in Microsoft homestead windows confirm that Double-click or ClickSaver isn't enabled. to try this, stick to those steps: a million. Open the Mouse properties communique field. to try this in homestead windows XP, click initiate, click Run, form important.cpl, and then click ok. 2. Use the applicable approach on your version of IntelliPoint utility. version 2.2 or before: on the StepSavers tab, click to clean the ClickSaver verify field. version 3.0 or a later version: on the Buttons tab, under Button project, confirm that the Left button placing is click (default), and not Double-click. click ok.