Anonymous
Anonymous asked in 社會與文化語言 · 1 decade ago

不良回覆 請翻譯成英文

經由現場主管及相關人員研討後發現此不良原因是因為管件厚度較厚,在擠製此類管件時會因為厚度越厚而使其偏心量越不易校正,其主因為管件在擠製程序中有一行程為"打心",當管件厚度不均時,較厚的厚度部分壓力會較大而使其穿心桿與模具無法成為一直線

針對此不良問題,我們將會使用鑽孔方式來改善,鑽孔的主要目的為在"打心"的動作上可以讓內膜更為精準,借以來改差偏心的問題

1 Answer

Rating
  • 1 decade ago
    Favorite Answer

    Find after discussing via on-the-spot executive and relevant personnel this bad reason is because the pipe fittings are relatively thick in thickness . The more difficult to correct will make it partial and measure because the thickness is the thicker while crowding and making this kind of pipe fittings . Its master has a journey in order to " send the heart " in crowding the procedure of making because of the pipe fittings, when the pipe fittings are uneven in thickness . Thicker some pressures of thickness will be greater and make it wear heart pole and mould it is unable to become a straight line

    Direct against this bad problem .We will use and hole the way will be improved .The main purpose to hole is more perfect for membrane in can let on movements of " making the heart "ing #

Still have questions? Get your answers by asking now.