why my 1999 chrysler lhs will not shift gears?

when i take off from a stand still the transmission will not change gears

3 Answers

Relevance
  • 1 decade ago
    Favorite Answer

    Likely in limp in mode indicating a fault has been detected by the transmission control module (TCM), either electronic sensor, actuator, circuit (wiring) or internal mechanical. Cost to repair is listed from least expensive to most expensive.

    Have the diagnostic codes pulled from memory, usually the TCM will have to be scanned and individual codes diagnosed, the CEL should be illuminated.

    Source(s): ASE Master certified 16 yrs.
    • Login to reply the answers
  • 3 years ago

    those are the indicators of low transmission fluid. With engine/transmission at wide-spread working temperature park on flat point floor, depart engine working, pull stick and wipe, insert and wait some seconds and pull decrease back out conserving it vertical so it won't run up the stick and supply an incorrect examining. it would be on the warm line. If no longer upload as needed. Then trypersistent. If it nonetheless slips, you will would desire to visit a save. the two the bands will would desire to be adjusted or worse a clean/rebuilt tranny.

    • Login to reply the answers
  • 1 decade ago

    Take it to the shop. It sounds like there's a problem internally. Check your fluid, if it smells like burnt root beer and is dark brown you have a serious problem.

    Source(s): Mechanic for 35 years
    • Login to reply the answers
Still have questions? Get your answers by asking now.