Im restoring a '78 Trans Am with Hurst Hatch t tops but im not which design that they are.3 AnswersPontiac2 months ago
The bolts that came with the steering wheel puller that I'm gonna use to remove the steering wheel from won't fit holes that they're supposed to go in on my Camaro's steering wheel.5 AnswersMaintenance & Repairs1 year ago
I'm building a scratch built '55 Chevy model car to look like the real '55 Chevy from the movie Two lane Blacktop and I want it to have a tilt front end just like the one in the movie but I don't wanna damage my model car.1 AnswerHobbies & Crafts4 years ago
I just took the old fuel tank of my Camaro and I'm gonna put a new one tank on my but I'm gonna use the fuel sending unit off my old tank I just need to know how to take the fuel sending unit off the old tank.3 AnswersMaintenance & Repairs5 years ago
- 3 AnswersChevrolet5 years ago
My Camaro ' s factory floor shifter cable won't fit the GMC truck transmission would the shifter cable the GMC truck fix my Camaro ' s factory floor shifter or could the factory shifter on my Camaro be modified to fit the GMC truck transmission?2 AnswersChevrolet5 years ago
I've been trying to hook up a Delco am fm 8 track player in my 1980 Camaro Z28 but I don't know which one is the hot wire there are 3 black ones one with a white stripe I know that one of them is the ground wire but there is also 1 orange wire 2 yellow wires 2 white wires and 2 grey wires. which one is the hot wire?
I've been trying to install the header panel on my 1980 Camaro I can get 2 nuts and bolts on the right of the header panel to tighten but when I lift up the left side to put on a couple of nuts and bolts the right side off. I've using 1/2 nuts and bolts on the nose / header panel is this the right size if not what size do I need?1 AnswerChevrolet6 years ago
I wanna tun ite so I can receive. I've got the S/RF SWR CAL switch on the S/RF position and I've got the RF gain turned counterclockwise and I do get a signal and I've turned the squelch counterclockwise but I can't hear any noise. Also the needle on the signal strength meter goes up to the CAL position on the meter when the RF gain. knob is turned all the way clockwise. Do I need to set the Delta Tune? Or what else do I need to do?4 AnswersRadio6 years ago
My 1981 Camaro does have the stock (factory) motor mounts on it4 AnswersChevrolet6 years ago
The rearend on my '76 Camaro is a posi traction Chevy 10 bolt. I know that the front of the driveshaft will bolt to the transmission because the driveshaft and transmission came from my 80 firebird. will the back of the Pontiac driveshaft bolt to my Camaro's Chevy 10 bolt rearend? And will the driveshaft be long enough?4 AnswersPontiac8 years ago
In the movie Summer dreams Story of Beach Boys whats the name of the song that Dennis Wilson sings and plays?
Here are some lyrics from the song: You can bring me joy with the simple words i love you.1 AnswerMovies8 years ago
The motor itself is a '76 Pontiac 400 that came out of my '80 Firebird. And how far apart do the motor mounts need to be on my '76 Camaro in order for the Pontiac 400 motor to fit?6 AnswersChevrolet8 years ago
Was it torn down or is it still standing? My 1969 Charger was made there3 AnswersDodge8 years ago
What happened to the other 1969 General Lee Dodge Chargers used in the Dukes of Hazzard GA episodes?
The first the 3 General Lee 1969 Dodge Chargers that were used in the first 5 Dukes of Hazzard episode that were filmed in GA were labled as Lee 1, Lee 2, and Lee 3. I do know that Lee 1 was found in a GA junkyard and was fully restored to look the way it did in the first Dukes of Hazzard episode One armed bandits. But what happened to the General Lees that were labled Lee 2 and Lee 3?3 AnswersDodge8 years ago